繁體版     English

E-mail:susan@brakepad.cn     +86-532-66736778

Welcome

News

Rear brake pad replacement tutorial

[Catalog:News] [Date:2021-10-9] [Hits:] [Return]

After removing the brake drum, you can see the brake drum by removing the tire. Tap the surface of the brake drum with a hammer and take it out after loosening the drum. Then remove the return torsion spring. First insert it into the gap of the torsion spring and lift it up with force to remove the return spring. If you want to remove the brake pad, this torsion spring must be removed.

Remove the fixing machine screw, and remove the screw fixing the immovable brake pad with pliers. There are two upper and lower brake pads on a wheel, and there are also two fixing machine screws.

Remove the upper, lower, left and right brake pads. After the above steps are completed, the brake pads will automatically fall off the brake system. At this moment, just obtain the brake pads. It is important to note that the small things on the brake pads should not be lost

Remove the locating pin from the old brake pad and install it on the new brake pad. After both sides are assembled, put it directly on the brake. It is also necessary to install the upper and lower brake pads separately in order.

After the brake pads are installed, the height of the brake pedal must be adjusted. Pulling out the ratchet wrench of the self-adjusting machine and equipment can reduce the brake pedal and pull up the brake pedal to make the brake system more effective, but it can not be too tight

After installing the brake pads and checking that there is no problem, you can install the brake drum and the tire.