[Catalog:News] [Date:2020-4-24] [Hits:] [Return]

The working principle of the brake is mainly from the friction, the use of brake pads and brake discs (drums) and tire and ground friction, the vehicle's kinetic energy into the friction after the heat, the car stopped. A well-established braking system must be able to provide a stable, adequate, controllable braking force, Accessories Of Brake Pad and has good hydraulic transmission and cooling capacity to ensure that the driver from the brake pedal of the force can be fully effective to the total pump And the sub-pump, and to avoid high heat caused by hydraulic failure and brake recession. 

The brake system on the car is divided into two categories: disc and drum, Accessories Of Brake Pad but in addition to the cost advantage, the drum brake is far less efficient than the disc brakes, so the brake system will only be disc brakes the Lord

Brake plate accessories: brake lining accessories (brake lining) generally by the steel plate, bonding insulation layer and friction block composition, steel plate to be coated to rust, coating process with SMT-4 furnace temperature tester to test the coating The temperature distribution of the process is ensured to ensure quality. The insulation layer is composed of non-heat transfer material, the purpose is to heat. Accessories Of Brake Pad The friction block is composed of friction material, adhesive, brake is squeezed in the brake disc or brake drum on the friction, so as to achieve the purpose of vehicle deceleration brake. Due to friction, the friction block will gradually be worn, in general, the lower the cost of the brake pads wear the faster wear. After the use of friction material to replace the brake pads in time, otherwise the steel plate and the brake disc will be in direct contact, Accessories Of Brake Pad and ultimately will lose the braking effect and damage the brake disc.