繁體版     English

E-mail:susan@brakepad.cn     +86-532-66736778

Welcome

News

Don't ignore these situations when braking!

[Catalog:News] [Date:2022-9-9] [Hits:] [Return]

When we discuss a certain model in our daily life

They often talk about their dynamic parameters

Such as displacement, power, torque, etc

however Run fast, and brake well at the critical moment!

Stronger power, we provide a refreshing driving experience

If we can stop, we can run further

In daily use, the braking system is also an area we often pay attention to. Most family cars on the market now adopt the design of front and rear disc brakes, while a small number of models adopt the design of front disc and rear drum. The braking principle of the disc brake is that when the driver steps on the brake pedal, the brake booster pump is pushed to squeeze the brake oil in the brake oil pipe, so that the piston in the brake caliper pushes the brake pad to rub against the brake disc, thereby achieving the effect of deceleration braking.

In fact, the braking system of a car is a very simple mechanical principle, which can ensure that the failure rate of the whole system is lower and safer. However, many old drivers will encounter various problems with the brake system, such as brake shaking, brake abnormal noise, brake weakness, brake pedal springing, etc. today, brother Tong will tell you about various failure phenomena and problems in the brake, and components that ensure life safety. Be careful!

Brake shake is that when you step on the brake, you can feel the shaking of the vehicle body or steering wheel, which is generally caused by the following three reasons.

First of all, the brake disc is worn abnormally, resulting in uneven surface of the brake disc. Therefore, when the brake is pressed, the vehicle or steering wheel shakes. Generally, in this case, you can first check the service life of the brake disc. If the service life has reached, you can directly replace the brake disc. If the brake disc can still be used, you can go to the repair shop to make a "disc", that is, polish the surface of the brake disc flat by polishing.