[Catalog:News] [Date:2020-10-10] [Hits:] [Return]

Brake plate accessories are generally made of steel plate, adhesive insulation layer and friction block. The steel plate is painted to rust, and the coating process uses SMT-4 furnace temperature tester to detect the temperature distribution of the coating process to ensure the quality. The insulation layer is composed of non-heat transfer material, the purpose is to heat. Friction block from the friction material, adhesive composition, the brake was squeezed in the brake disc or brake drum on the friction, so as to achieve the purpose of vehicle braking. Due to friction, the friction block will gradually be worn, in general, the lower the cost of the brake pads wear the faster wear. After the use of friction material to replace the brake pads in time, Accessories Of Brake Pad otherwise the steel plate and the brake disc will be in direct contact, and ultimately will lose the braking effect and damage the brake disc. The working principle of the brake is mainly from the friction, the use of brake pads and brake discs (drums) and tire and ground friction, the vehicle's kinetic energy into the friction after the heat, the car stopped. Accessories Of Brake Pad A well-established braking system must be able to provide a stable, adequate, controllable braking force and a good hydraulic transmission and cooling capability to ensure that the force applied by the driver from the brake pedal is fully effective And the sub-pump, and to avoid high heat caused by hydraulic failure and brake recession. The brake system on the car is divided into two categories: disc and drum, but in addition to the cost advantage, the drum brake is far less efficient than the disc brakes, so the brake system will only be disc brakes the Lord.

The working principle of the brake is mainly from the friction, the use of brake pads and brake discs (drums) and tire and ground friction, the vehicle's kinetic energy into the friction after the heat, the car stopped. A well-established braking system must be able to provide a stable, adequate, Accessories Of Brake Pad controllable braking force and a good hydraulic transmission and cooling capability to ensure that the force applied by the driver from the brake pedal is fully effective And the sub-pump, and to avoid high heat caused by hydraulic failure and brake recession. The brake system on the car is divided into two categories: disc and drum, Accessories Of Brake Pad but in addition to the cost advantage, the drum brake is far less efficient than the disc brakes, so the brake system will only be disc brakes the Lord

The composition of the brake pads The brake lining (brake lining) generally consists of steel plate, bonding insulation layer and friction block, the steel plate to be painted to rust, coating process with SMT-4 furnace temperature tester to detect the coating The temperature distribution of the process ensures quality. The insulation layer is composed of non-heat transfer material, the purpose is to heat. Accessories Of Brake Pad Friction block from the friction material, adhesive composition, the brake was squeezed in the brake disc or brake drum on the friction, so as to achieve the purpose of vehicle braking. Due to friction, the friction block will gradually be worn, in general, the lower the cost of the brake pads wear the faster wear. After the use of friction material to replace the brake pads in time, otherwise the steel plate and the brake disc will be in direct contact, and ultimately will lose the braking effect and damage the brake disc.