At its most basic, a brake system converts the kinetic energy of a car into heat energy through friction devices -- namely the pads. How much kinetic energy is at work in a car is determined by its weight (I use this interchangeably with mass thought the two are not exactly the same), its speed and how much the speed changes. From a physics standpoint, kinetic energy is calculated by multiplying the weight of the car times the square of its speed. The product is then divided by 29.9 and the result is the amount of kinetic energy in foot-pounds.

A more practical application is this: Two cars are traveling at 30 miles per hour (48.3 kilometers per hour). One weighs 2,000 pounds (907.2 kilograms), the other 4,000 pounds (1,814 kilograms). The lighter car is generating 60,200 foot-pounds (81,620 newton-meters) of kinetic energy, the heavier car is generating 120,400 foot-pounds (163,240 newton-meters) of kinetic energy.

Our theoretical car is traveling and generating torque and essentially nothing is happening until the driver steps on the brake. Then a whole bunch of things happen. The brakes must overcome dynamic inertia (the car in motion) and impose static inertia (make the car come to a stop). It does this by changing the kinetic energy to thermal energy or heat -- and it generates a lot. The pads on the smaller car going 60 miles per hour (96.6 kilometers per hour) will reach about 450 degrees Fahrenheit (232.2 degrees Celsius) during an emergency stop. This, of course, can affect the life of the pad. Or, more simply put, every time a driver stops, or rides the brakes, the pads wear down, heat up and die just a little bit.

The final portion of this long equation on pad life has nothing to do with the pads directly. Remember, the pads must press against a rotor to slow the car. This is accomplished using a set of calipers, and the pads are pressed against a rotor.

Similarly, the calipers must work to correctly apply the piston and press the pads when needed, and release when not needed, too. A stuck or sticking caliper can mean a pad is in constant or too-frequent pressurized contact with a rotor. This increases the heat energy and premature wearing away of the pad.

The variables in a brake pad's life are so wide that setting a specific lifespan is almost impossible -- although 30,000 to 50,000 miles (48,280 to 80,467 kilometers) for semimetallic pads is a good guesstimate. Even the type of transmission a car has can affect pad life. Manual transmission drivers who know how to shift to control speed will see longer brake life than automatic transmission drivers.

 On the other end of the spectrum, people who ride the brakes, or brake very hard, often see their pad life halved when a simple shift in driving style could save them money.

Given this variety, the best way to handle pad life is to have them checked during routine oil changes. A set of brake pad gauges can be used to measure wear, and a good shop can tell you how much friction material you have left on the pad and how long they should last. Many pads have audible indicators as well. A small piece of metal, usually a spring clip, attached to one of the pads. When the pad wears down, the clips rub against the rotor and make a squealing noise.

Regardless of how long typical brake pads may last, always pay attention to the signs of brakes going bad -- fading power, loss of power when the brakes get hot, or pulling to one side or another during braking. All of these signs are an indication of brake pads going bad, and brakes are critical to a car's good operation.